论文标题
减少7T人类大脑双重翻转角度T1映射的偏差
Reducing bias in dual flip angle T1-mapping in human brain at 7T
论文作者
论文摘要
目的:通过优化翻盖角对并仔细选择RF脉冲形状和持续时间,以7T的全脑双重角(DFA)T1映射解决系统偏置。理论和方法:变质的梯度回声可用于估计T1的全脑图。这可以通过仅使用两个具有不同翻转角度的收购来完成,即基于DFA的方法。尽管基于DFA的T1映射似乎很容易实施,但它对不完全破坏和偶然磁化转移(MT)效应引起的偏见很敏感。在7T时,B0和B1+不均匀性增加引入了进一步的偏见。进行实验以确定最佳的翻转角对以及适当的RF脉冲形状和持续时间。使用倒置恢复EPI验证了获得的T1估计值,并将其与文献值进行了比较。使用多回声读数来增加SNR,实现R2*的定量和敏感性,X。结果:在大约20度的局部翻转角上观察到不完整的变质。恒定持续时间为700 US的不对称高斯过滤SINC脉冲表现出足够平坦的频率响应曲线,以避免在B0较高偏移的区域中不完全激发。脉搏持续时间为700 US,最大程度地减少了偶然MT的影响。结论:执行基于DFA的T1映射时,应该(i)限制更高的翻转角度以避免不完全变质,(ii)使用对B0不均匀性不敏感的RF脉冲形状,并且(iii)施加恒定的RF脉冲持续时间,平衡以最大程度地减少偶然MT。
Purpose: To address the systematic bias in whole-brain dual flip angle (DFA) T1-mapping at 7T by optimizing the flip angle pair and carefully selecting RF pulse shape and duration. Theory and Methods: Spoiled gradient echoes can be used to estimate whole-brain maps of T1. This can be accomplished by using only two acquisitions with different flip angles, i.e., a DFA-based approach. Although DFA-based T1-mapping is seemingly straightforward to implement, it is sensitive to bias caused by incomplete spoiling and incidental magnetization transfer (MT) effects. Further bias is introduced by the increased B0 and B1+ inhomogeneities at 7T. Experiments were performed to determine the optimal flip angle pair and appropriate RF pulse shape and duration. Obtained T1 estimates were validated using inversion recovery prepared EPI and compared to literature values. A multi-echo readout was used to increase SNR, enabling quantification of R2* and susceptibility, X. Results: Incomplete spoiling was observed above a local flip angle of approximately 20 degrees. An asymmetric gauss-filtered sinc pulse with a constant duration of 700 us showed a sufficiently flat frequency response profile to avoid incomplete excitation in areas with high B0 offsets. A pulse duration of 700 us minimized effects from incidental MT. Conclusion: When performing DFA-based T1-mapping one should (i) limit the higher flip angle to avoid incomplete spoiling, (ii) use a RF pulse shape insensitive to B0 inhomogeneities and (iii) apply a constant RF pulse duration, balanced to minimize incidental MT.